The determination of total organic carbon in soils, fertilizers, sewage sludge, sediments, and humic extracts is widely performed by chemical oxidation methods with K2Cr2O7. The Yeomans-Bremner (YB) method is currently the one that stands out the most. The drawback of these methods is the large amount of concentrated H2SO4 used, which generates a large amount of hazardous waste. This work proposes using KMnO4 as an alternative to K2Cr2O7 for a lower consumption of H2SO4. The method uses the back titration of Fe2+ added to consume both the MnO2 produced and the excess KMnO4 that was not consumed in the OM oxidation. A non-trivial and yet not explored stoichiometry was applied for this purpose, providing a success not yet achieved in using permanganate to determine TOC by titration. The ideal condition for the oxidation of OC was determined by the analysis of a potassium hydrogen phthalate standard and involved the use of 0.125 mol L-1 H2SO4 and temperature of 70 °C, obtaining a significant advantage over the YB method (concentrated H2SO4 and 170 °C). The proposed method was applied to the analysis of soil samples, producing conversion factors for soil organic carbon that varied between 0.652 and 1.12.

Wavelength dispersion X-ray fluorescence spectrometry (WDXRF) is a non-destructive technique and therefore attractive for gunshot residues (GSR) analysis. It is well known for determination of inorganic constituents of samples. However, X-ray scattering region spectral data is not commonly used, although it may provide information about organic constituents and their interactions. This work employed X-ray scattering region and inorganic elements spectral data for a better characterization of GSR. Swabs containing residues collected from the hand of people who fired (shooters group) and also from the hands of people which did not fire (control group) with guns were analyzed directly by the WDXRF. Brake pad and people who perform activities that favor the accumulation of characteristic elements of GSR on their hands were chosen to compose the control group. Principal components analysis (PCA) discriminated the GSR according to the firearm/cartridge used. However, similar GSR clustering did not occur without X-ray scatter data, showing the importance of X-ray scattering spectrum for GSR evaluation. The k-nearest neighbors (k-NN) method correctly classified all samples from shooters and control groups, employing from 1 to 5 nearest neighbors. No anomalous behavior was detected by PCA and hierarchical cluster analysis (HCA).

Oxidative stability parameters (OSP), acid value (AV), water content (W), and the metallic copper corrosion rate in biodiesels obtained from eight different vegetable oils were determined. Simple and multiple linear regression models were constructed to explain the influence of the OSP, AV and W variables on the corrosion rate. The corrosion rate was lower in biodiesel with less oxidative stability because, instead of reacting with copper, O2 reacted preferentially with the unsaturated fatty acid methyl esters (FAME) that could act as “sacrificial molecules” to protect the copper against corrosion. Therefore, the corrosion rate was strongly related to the FAME composition. The AV was an important parameter in the corrosion process because free acids react with passivating agents, increasing the corrosion rate. The predictive capacity of W for corrosion rate was statistically insignificant, although water condensed on a copper surface causes corrosion.

Biodiesel synthesis from soybean oil using methanol and alkaline catalysts occurs in the following two consecutive steps: dispersion of methanol in the oil and methanolysis. The effect of the alkaline catalysts NaOCH3, KOCH3, NaOH, and KOH in the dispersion step at 30-60 ºC and under mechanical stirring at 400 rpm was evaluated. The dispersion step accounts for 44.6-73.3% of the total synthesis time and was poorly favored compared to methanolysis due to the increase in temperature. The catalysts decreased the dispersion time, although most of them increased the methanol-oil interfacial tension. K-containing catalysts were more active than their Na analogues due to higher adsorption of K+ in the methanol-oil interface and the higher production of methyl esters (which act as emulsifying agents), which promote a more favorable interfacial tension. The alkaline cation effect was more significant in the dispersion step than in the methanolysis step.

Volhard method is extensively employed in the teaching laboratories of classical quantitative analysis to chloride determination and is based on the reaction of Ag+ with Cl- and Ag+ residual titration with SCN-. Its drawback is that SCN- reacts with the AgCl(s) initially formed. Nitrobenzene is used to avoid this stripping, but it is toxic to the environment and causes problems in final disposal. This work proposed the use of soybean oil as an alternative to nitrobenzene. The traditional and modified methods were applied in the standardization of 0.05 mol L-1 KSCN solution employing 0.05000 mol L-1 NaCl standard and the proposed modification did not affect the results obtained (α = 0.05). No significant differences were observed in the variances and NaCl recovery percentage in the titration of aliquots of 5.00 to 15.00 mL of solution of this salt. The recovery percentages obtained with soybean oil on the titration of synthetic 0.07000 mol L-1 NaCl samples diluted 1:1 to 1:100 were equivalent and even better than with nitrobenzene. The chloride determination in samples of saline, whey cheese, sea water and olive brine obtained by the modified method was satisfactory when compared to the official method with relative errors below 3%.

O biflavonóide 2",3"-diidroochnaflavona, isolada de espécies de Luxemburgia (Ochanaceae), foi tratada com diazometano e forneceu o éter trimetílico que, em seguida, foi tratado com anidrido acético/piridina obtendo-se um novo derivado, 5-acetil-7,4'-dimetil-flavona-(3'→O-4'")-5"-acetil-7"-metil-flavanona. Fez-se o completo assinalamento dos dados de RMN ¹H e 13C através da análise dos espectros uni- e bidimensionais do derivado.

The biflavonoid 2",3"-dihydroochnaflavone, isolated from the Luxemburgia species (Ochanaceae), was treated with diazomethane to obtain the trimethyl-ether that was treated with pyridine/acetic anhydride to yield a new derivative, 5-acetil-7,4'-dimethyl-flavone-(3'→O-4'")-5"-acetil-7"-methyl-flavanone. The complete ¹H and 13C NMR data assignments of the new derivative were made by the one- and two-dimensional spectral analysis.